The Rice Straw Tying Device Parameters Using UG Software to Establish Three-Dimensional Model of Rice Harvest Tying Device Baling Machine
AUTHORS
Ying-nan LIU,College of Electrical and Information, Heilongjiang Bayi Agricultural University, Daqing 163319, China
Shu-juan YI*,College of Engineering, Heilongjiang Bayi Agricultural University, Daqing 163319, China
Dian-qi Sun,College of Engineering, Heilongjiang Bayi Agricultural University, Daqing 163319, China
ABSTRACT
With the improvement of the utilization rate of straws, the recovery question of rice straw has been focused. In the past, the recovery of rice straw needs a lot of manpower. also need to be equipped with a vehicle, most of bundling machine were traction type bundling machine in domestic, secretary was inefficient, this greatly increases the cost of recycling, and the recovery of straw caused two compactions of soil, so that farmers will burn a lot of straw, cause pollution of the environment. Therefore, this study is based on the whole feeding rice combine harvester. added the straw bale device, One-time finished the rice harvesting, threshing cleaning and warehousing and Rice straw compression, bale and other processes. Improve the recovery efficiency of rice straw, reduce the cost of straw recovery, reduced the number of mechanicals going in the fields. In this paper using UG software for the rice harvest tying device baling machine 3 d drawing, and carries on the kinematics simulation, the simulation for bundling device compression mechanism motion state laws.
KEYWORDS
Rice harvesting bundling machine, Bundling apparatus, Virtual simulation
REFERENCES
[1] LuJie, “Straw baling machine type D knot structure and parameter optimization research,” The northeast agricultural university, (2014)
[2] Lee Ka Leung and Zhang Liang, “Trial report on yield of different forage maize varieties,” Journal of Animal Husbandry and veterinary medicine, vol.35, no.1, pp.103-104, (2016)
[3] Xia Debin, “Nanshan district and alfalfa mechanical harvest after experimental study,” Journal of modern animal husbandry, pp.30-43, (2014)
[4] Liu Xinzhu and Daniel, “The rice and wheat straw baler compression mechanism design and mechanical analysis,” Journal of Jiamusi university, (2014)
[5] Tang Han, “Study on design and mechanism of finger-clip precision metering device for corn with corrugated curved surface,” Harbin: Northeast Agricultural University, (2018)
[6] Ma Jun, “Introduction to comprehensive utilization of crop straw resources in Heilongjiang province present situation and the suggested,” Journal of feed and the environment, (2014)
[7] Qu Hongchao, Bao Shuai, Yi Shujuan, etc., “Simulation and analysis of the bundling device of rice harvesting and bundling machine,” Research on agricultural mechanization, no.11, pp.59-63, (2017)
[8] Li Fei jump and jian-fei wang, “China’s grain crop straw burning carbon conversion and biochar carbon amount calculations,” Journal of Agricultural Engineering, pp.14:1-7, (2013)